Multi-input Rectifier Stage for Hybrid Renewable Energy System
M Pandikumar1, R Sundreswaran2* and M Shnamugapriya2
1Department of Electrical and Electronics Engineering, Sri Sivasubramaniya Nadar College of Engineering, Tamil Nadu, India
2Department of Mathematics, Sri Sivasubramaniya Nadar College of Engineering, Tamil Nadu, India
*Corresponding Author: R Sundreswaran, Department of Mathematics, Sri Sivasubramaniya Nadar College of Engineering, Tamil Nadu, India.
Received:
May 14, 2022; Published: July 18, 2022
Abstract
Concern over the state that our planet is in as it continues to deteriorate is causing environmentally friendly solutions to become more popular than ever. Because of environmental concerns, green solutions are becoming increasingly popular. In this paper, a redesigned rectifier stage is applied to an example of a hybrid energy system. The load can be supplied by either of the two sources, based on how readily it can be met by the various sources of energy, in this configuration. In order to get rid of higher order harmonics, this fused converter with a Cuk-SEPIC, does not require any additional input filters to be installed. The presence of the harmonics has a negative impact on the generator's lifespan, heating issues, and overall performance.. Due to its fused rectifier with multiple inputs, the maximum power point tracking (MPPT) can be utilised whenever wind and sunlight are available to generate electricity. When it comes to wind and PV, we'll use an adaptive MPPT algorithm and a common perturb and observe procedure. The proposed system's operational analysis will be discussed in this paper. For the sake of emphasising the advantages of the circuit under consideration, simulation results are presented. When one energy source isn't able to keep up with the demand, another can step in to fill the gap. MPPT control has been proposed for a number of hybrid wind/PV systems, and in addition to that, the utilisation of rectifiers and inverters has been debated.
Keywords: Wind Energy; Solar Photovoltaics; SEPIC Converter; Cuk Converter; Hybrid Systems
References
- Rahman KM., et al. “Application of direct-drive wheel motor for fuel cell electric and hybrid electric vehicle propulsion system”. IEEE Transactions on Industry Applications5 (2006): 1185-1192.
- Hinkkanen M and Luomi J. "Induction motor drives equipped with diode rectifier and small DC-link capacitance”. IEEE Transactions on Industrial Electronics1 (2008): 312-320.
- Rivetta C H., et al. “Analysis and control of a buck DC-DC converter operating with constant power load in sea and undersea vehicles”. IEEE Transactions on Industry Applications2 (2006): 559-572.
- Kim SK., et al. “Dynamic modeling and control of a grid-connected hybrid generation system with versatile power transfer”. IEEE Transactions on Industrial Electronics4 (2008): 1677-1688.
- Rodriguez J., et al. “Multilevel inverters: a survey of topologies, controls, and applications”. IEEE Transactions on Industrial Electronics4 (2002): 724-738.
- Ahmed NA., et al. “Power fluctuations suppression of stand-alone hybrid generation combining solar photovoltaic/wind turbine and fuel cell systems”. Energy Conversion and Management10 (2008): 2711-2719.
- Jain S and Agarwal V. "An integrated hybrid power supply for distributed generation applications fed by nonconventional energy sources”. IEEE Transactions on Energy Conversion2 (2008): 622-631.
- Tolbert L M., et al. “Multilevel PWM methods at low modulation indices”. IEEE Transactions on Industrial Electronics4 (2000): 719-725.
- Chen YM., et al. “Multi-input inverter for grid-connected hybrid PV/wind power system”. IEEE Transactions on Industrial Electronics3 (2007): 1070-1077.
- Ganesh P., et al. “A renewable hybrid wind solar energy system fed single phase multilevel inverter”. International Journal of Engineering Research and Technology (IJERT)1 (2014).
- Challa D and Inguva R. "An inverter fed with combined wind-solar energy system using CUK-SEPIC converter.”. International Journal of Engineering Research and Technology 9 (2012): 1-8.
- Shen M and Peng FZ. "Operation modes and characteristics of the Z-source inverter with small inductance or low power factor”. IEEE Transactions on Industrial Electronics1 (2008): 89-96.
- Al-Buraiki AS., et al. “Hydrogen production via using excess electric energy of an off-grid hybrid solar/wind system based on a novel performance indicator”. Energy Conversion and Management, 254 (2022): 115270.
- Bakhtvar M., et al. “A vision of flexible dispatchable hybrid solar‐wind‐energy storage power plant”. IET Renewable Power Generation13 (2021): 2983-2996.
- Bakir H and Kulaksiz A A. “Modelling and voltage control of the solar-wind hybrid micro-grid with optimized STATCOM using GA and BFA”. Engineering Science and Technology, an International Journal3 (2020): 576-584.
- Cao Y., et al. “Design, dynamic simulation, and optimal size selection of a hybrid solar/wind and battery-based system for off-grid energy supply”. Renewable Energy 187 (2022): 1082-1099.
- Diab AAZ., et al. “Optimal sizing of hybrid solar/wind/hydroelectric pumped storage energy system in Egypt based on different meta-heuristic techniques”. Environmental Science and Pollution Research26 (2020): 32318-32340.
- Ekren O., et al. “Sizing of a solar-wind hybrid electric vehicle charging station by using HOMER software”. Journal of Cleaner Production 279 (2021): 123615.
- Eryilmaz S., et al. “Reliability based modeling of hybrid solar/wind power system for long term performance assessment”. Reliability Engineering and System Safety 209 (2021): 107478.
- Guangqian D., et al. “A hybrid algorithm based optimization on modeling of grid independent biodiesel-based hybrid solar/wind systems”. Renewable Energy 122 (2018): 551-560.
- Javed M S., et al. “Techno-economic assessment of a stand-alone hybrid solar-wind-battery system for a remote island using genetic algorithm”. Energy 176 (2019): 704-717.
- Kamel S., et al. “Sizing and evaluation analysis of hybrid solar-wind distributed generations in real distribution network considering the uncertainty”. 2019 International Conference on Computer, Control, Electrical, and Electronics Engineering (ICCCEEE) (2019).
- Masih A and Verma H. “Optimization and reliability evaluation of hybrid solar-wind energy systems for remote areas”. International Journal of Renewable Energy Research (IJRER)4 (2020): 1697-1706.
- Mehrjerdi H. “Modeling and optimization of an island water-energy nexus powered by a hybrid solar-wind renewable system”. Energy 197 (2020): 117217.
- Peng W., et al. “Optimization of a hybrid system for solar-wind-based water desalination by reverse osmosis: comparison of approaches”. Desalination 442 (2018): 16-31.
- Sen A., et al. “A comparative analysis between two DPFC models in a grid connected Hybrid Solar-Wind Generation system”. 2020 IEEE International Conference on Power Electronics, Smart Grid and Renewable Energy (PESGRE2020) (2020).
- Shivaie M., et al. “A reliability-constrained cost-effective model for optimal sizing of an autonomous hybrid solar/wind/diesel/battery energy system by a modified discrete bat search algorithm”. Solar Energy 189 (2019): 344-356.
- Tahiri F., et al. “Optimal management energy system and control strategies for isolated hybrid solar-wind-battery-diesel power system”. Emerging Science Journal2 (2021): 111-124.
- Xu B., et al. “Modeling a pumped storage hydropower integrated to a hybrid power system with solar-wind power and its stability analysis”. Applied Energy 248 (2019): 446-462.
- Yang J., et al. “Optimal capacity and operation strategy of a solar-wind hybrid renewable energy system”. Energy Conversion and Management 244 (2021): 114519.
- Zhang W., et al. “Sizing a stand-alone solar-wind-hydrogen energy system using weather forecasting and a hybrid search optimization algorithm”. Energy Conversion and Management 180 (2019): 609-621.
Citation
Copyright